Please change the cut-off voltage to 2.9V or 3.0V. If the motor stops rotating and you heard twice beeps, the voltage is under the set value. If no work until the increased timing angle to 30, means the motor is overloaded, please change to use a smaller propeller or lower the voltage or change to a better motor. If a noise occurred during accelerating, please increase the timing angle.Pay attention to the polarity, wrong polarity connection will cause ESC and motor damage!.If the motor rotation direction is wrong, you can exchange any two of the three motor cables to correct it.ESC can only be powered by batteries, DO NOT connect ESC to AC power directly! OBS:.Otherwise, it will reduce the useful life of the motor and ESC. Don’t operate continually when the motor was blocked. Always keep all the things away from the propeller when working on a power system with the battery connected.Please don’t let ESC overvoltage for a long time, otherwise will short the usage life of ESC.Please don’t operate long time when the ESC is over-temperature, otherwise, it will damage the MOS FET easily.It will reduce the battery usage life and ESC working efficiency. Please don’t operate for a long time with the battery under voltage.Please strictly follow the instructions to DETAILS SETTINGS WITH PROGRAMMING CARDĭue to the brushless power system is powerful, improper use may cause personal injury and device damage. For example, using a 4s battery, beeps will be: “ “. Power on the controller and set the throttle stick to the Min throttle position (if higher than1800us, it will get into throttle calibration).Ĭonnect ESC as connection diagram, power on ESC, ESC will automatically detect the battery cells and using beeps to indicate the cells number. Set the throttle stick at middle-> Power on ESC->A sequence beeps and then follow with single and repeat DD-, means now it’s in controller brake setting procedure -> move the throttle stick to Max throttle position (means Brake is ON), or move the throttle stick to Min throttle position (means Brake is OFF)->a sequence beeps means setting ok and followed 2 beeps “means ESC is ready to go. Setting (Brake ON/Brake OFF) by the controller.Move the throttle stick to the lowest position, motor beeps “ means the low position is set, then another “ “” as confirmation that throttle is set ok and ready to go. Power on the ESC, motor beeps “, means high position throttle is set. Step 1: Power on the controller and move the throttle stick to the highest position. Please set the throttle range when you first time to use the ESC. It supports the setting of the direction of motor rotation by prog-card.60A and above supports adjustable temperature protection.Customized settings can be done with prog-card and controller (Brake/Non-Brake).The regular throttle range is 900us-2400us. Different PWM frequencies can be set by a programming card. PWM output frequency range is 8-32KHz.Support 6A-150A, 2-8S (Please check ESC sticker to verify the specified cells and power, more high voltage model to be added). TURNIGY PLUSH 80A ESC MANUAL SOFTWARE
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |